ASTM A381 PDF

The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending, flanging, corrugating, and similar operations. For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed. The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets.

Author:Micage Tygor
Country:Iceland
Language:English (Spanish)
Genre:Technology
Published (Last):7 March 2018
Pages:179
PDF File Size:15.5 Mb
ePub File Size:9.12 Mb
ISBN:572-5-93944-569-8
Downloads:95729
Price:Free* [*Free Regsitration Required]
Uploader:Bamuro



Covers metal-arc-welded steel pipe for use with high pressure transmission systems. The pipe is intended for fabrication of fittings and accessories for compressor or pump -station piping. The required chemical composition for carbon steel, and the tensile properties of finished pipes are presented. Mechanical testing requirements namely transverse body tension test and transverse weld tension test shall be performed on each length of pipe from each lot of lengths, and transverse guided- bend weld test cut from a length of pipe from each lot of 50 length, also hydrostatic test from each length of pipes shall be performed.

A radiographic examination shall also be performed to ensure that the welding equipment is consistently producing the required quality.

This specification covers straight seam, double-submerged-arc-welded steel pipe Note 1 suitable for high- pressure service, 16 in. The pipe is intended for fabrication of fittings and accessories for compressor or pump-station piping. Pipe ordered to this specification shall be suitable for bending , flanging vastoning , corrugating , and similar operations. The term "double welded" is commonly used in the gas and oil transmission industry, for which this pipe is primarily intended, to indicate welding with at least two weld passes, of which one is on the outside of the pipe and one on the inside.

For some sizes of the pipe covered by this specification, it becomes expedient to use manual welding, in which case the provisions of Note 3 shall be followed. Nine classes of pipe, based on minimum yield point requirements, are covered as indicated in Table 1. The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate. The following hazard caveat applies to the test methods portion, Sections 9 and 10, only.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Stainless Steel Products.

Standard Specification. Stainless Pipe Dimensions. Material Grades. Chemical Composition. Mechanical Properties. Technology Flow chart. Range of Applications. Producing Equipment. Testing Equipment. Quality Control. Contact US.

KROLEWSKI SKRYTOBOJCA PDF

ASTM A381 Class Y 35 Stress-relieved, Normalized, or Quenched and Tempered

Prices subject to change without notice. About Us. Contact Us. Sign In. Standards Store.

LPC2148 PROGRAMMING IN C PDF

ASTM A381 / ASME SA381 / Metal Arc Welded Steel Pipe supplier & distributor in India

Covers metal-arc-welded steel pipe for use with high pressure transmission systems. The pipe is intended for fabrication of fittings and accessories for compressor or pump -station piping. The required chemical composition for carbon steel, and the tensile properties of finished pipes are presented. Mechanical testing requirements namely transverse body tension test and transverse weld tension test shall be performed on each length of pipe from each lot of lengths, and transverse guided- bend weld test cut from a length of pipe from each lot of 50 length, also hydrostatic test from each length of pipes shall be performed. A radiographic examination shall also be performed to ensure that the welding equipment is consistently producing the required quality.

Related Articles