Owner's Manuals. Manual Description The system will shut the engine off in two 2 lets will remain active for up to 10 minutes after the seconds if someone uses an invalid key to start the 2 ignition switch is turned off. Operation begins to flash after the bulb check, it indicates that is automatic, regardless of whether the vehicle is locked someone used an invalid key to start the engine. This will prevent the lost key from starting your activated, the system provides both audible and visual vehicle.

Author:Kazik Yozshuktilar
Language:English (Spanish)
Published (Last):13 February 2008
PDF File Size:9.68 Mb
ePub File Size:17.27 Mb
Price:Free* [*Free Regsitration Required]

Quick Links. Download this manual. Table of Contents. Automobile Chrysler Specification 8 pages. It is supplemented by a Warranty Information Booklet and various customer oriented documents. You are urged to read these publications carefully. Page 5: How To Use This Manual Failure to use driver and passenger seat belts provided is a major cause of severe or fatal injury. In fact, the U. If you do not read this entire manual you may miss important information.

Any modifications or alterations to this vehicle could seriously affect its roadworthiness and safety and may lead to an accident resulting in serious injury or death. These numbers can be used to order duplicate keys from your dealer. Ask your dealer for these numbers and keep them in a safe place. If this occurs, rotate the key to the right slightly, then remove the key as described.

If a malfunction occurs, the system will trap the key in the ignition cylinder to warn you that this safety feature is inoperable. Push in on the key in the ignition lock cylinder to rotate to the LOCK position. Page Sentry Key - If Equipped For vehicles equipped with the Electronic Vehicle Infor- mation Center EVIC , the power window switches, radio, hands—free system if equipped , and power out- lets will remain active for up to 10 minutes after the ignition switch is turned off.

Opening either front door will cancel this feature. Should this occur, have the vehicle ser- viced as soon as possible. Page General Information 4. Insert a blank Sentry Key into the ignition switch and turn the ignition switch ON within 60 seconds. After 10 seconds a single chime will sound and the Vehicle Theft Alarm Indicator Light will stop flashing, turn on again for 3 seconds, and then turn off.

After all the doors are locked and closed the security light in the instrument cluster will flash rapidly to signal that the system is arming. The interior lights will remain on for 30 seconds after the last door is closed, or until all doors are closed and either the ignition is turned to the ON position or a key fob LOCK button is pressed.

This system allows you to lock or unlock the doors and liftgate or activate the panic alarm from distances a minimum of 66 feet 20 meters using a hand held radio transmitter. If the desired programming was not achieved or to reactivate this feature, repeat the above steps. To lock the doors and liftgate: Press and release the LOCK button on the key fob to lock all doors and liftgate. If the ignition is OFF, when the doors are locked, the parking lights will flash on once and the horn will chirp once.

If your Remote Lock Control fails to operate from a normal distance, check for these two conditions. When a single chime is heard release both buttons. The chime is an indication that you have successfully entered program mode. All fobs that are to be programmed must be done so within 60 seconds of when the chime was heard.

Remove and replace the batteries. Avoid touching the new batteries with your fingers. Skin oils may cause battery deterioration. If you touch a battery, clean it with rubbing alcohol. To indicate that the vehicle is about to start, the parking lights will flash and the horn will sound briefly. Remote Start Transmitter Once the vehicle has started, the engine will run for 15 minutes. Page Door Locks The vehicle can be started remotely up to a maximum of two times.

The vehicle is also allowed a maximum of one failed start, where the remote start sequence was initiated but cancelled before the engine begins to crank. After either of these conditions, or if the Vehicle Theft Alarm is alarming, or if the PANIC button was pressed, the vehicle must be reset by inserting a valid key into the ignition Use this switch to lock or unlock the doors. Power Door Lock Switch If you press the power door lock switch while the key is in the ignition, and any front door is open, the power locks will not operate.

Page 29 3. Place the key into the ignition. A single chime will sound to indicate the feature has been changed. Repeat the above steps to alternate the availability of this feature. Avoid trapping anyone in a vehicle in a collision. Remember that the rear doors can only be opened from the outside when the child protection locks are engaged.

NOTE: After setting the child protection door lock system, always test the door from the inside to make certain it is in the desired position.

This feature can be turned off by your authorized dealer. Re- move the obstacle and use the window switch again to close the window. Any impact due to rough road condi- tions may trigger the auto reverse function unexpectedly during auto closure. The emergency liftgate latch release can be accessed through a snap-in cover located on the lift- gate trim panel. If the liftgate is not fully open, press the remote keyless entry transmitter or overhead console button to fully open the liftgate and then press again to close.

You and your passengers could be injured by these fumes. Keep the liftgate closed when you are operating the vehicle. In a collision, you and your passengers can suffer much greater injuries if you are not properly buck- led up. You can strike the interior of your vehicle or other passengers, or you can be thrown out of the vehicle. It is extremely dangerous to ride in a cargo area, inside or outside of a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed.

Do not allow people to ride in any area of your vehicle that is not equipped with seats and seat belts. Enter the vehicle and close the door. Sit back and adjust the seat. Pulling Out Belt and Latchplate 2. The seat belt latch plate is above the back of the front seat, next to your arm in the rear seat. The lap portion could ride too high on your body, possibly causing internal injuries. Always buckle your belt into the buckle nearest you. Always wear the lap belt as low as pos- sible and keep it snug.

Push in on the anchorage release button to release the anchorage, and then move it up or down to the position that serves you best. Second Row Center Seat Belt The center seating position in the second row has a seat belt assembly that can be converted from the normal emergency locking mode to the automatic locking mode. Programming mode will be cancelled after the feature has toggled with the seat belt still buckled or if the ignition switch is turned to the lock position or 10 seconds after the feature has toggled.

You may damage the airbags and you could be injured be- cause the airbags are no longer functional. These protective covers for the airbag cushions are de- signed to open only when the airbags are inflating.

Page 53 Here are some simple steps you can follow to minimize the risk of harm from a deploying airbag. Children 12 years and under should always ride buckled up in a rear seat in an appropriate child restraint.

Infants in rear-facing child restraints should NEVER ride in the front seat of a vehicle with a passenger front airbag. The airbags work with your seat belt to restrain you properly. Always wear your seat belts even though you have airbags. The front airbag inflators are de- signed to provide different rates of airbag inflation from direction provided by the ORC. The ORC will not detect roll over.

When the ORC detects a collision requiring the airbags, it signals the inflator units. Al- ways use the correct seat cover specified for the vehicle. As the airbags deflate you may see some smoke-like particles. The particles are a normal by- product of the process that generates the nontoxic gas used for airbag inflation. You could be injured if the airbag system is not there to protect you. Do not modify the components or wiring, including adding any kind of badges or stickers to the steering wheel hub trim cover or the upper right side of the instrument panel.

NOTE: If the speedometer, tachometer or any engine related gauges are not working, the airbag control mod- ule may also be disabled. The airbags may not be ready to inflate for your protection. Page 61 may be released for incorporation in aggregate crash databases, such as those maintained by the US govern- ment and various states. Data of a potentially sensitive nature, such as would identify a particular driver, ve- hicle, or crash, will be treated confidentially.

Confidential data will not be disclosed by DaimlerChrysler Corpora- tion to any third party except when: 1. Every state in the United States and all Canadian provinces require that small children ride in proper restraint systems.

An airbag deployment could cause severe injury or death to infants in this position. Never allow a child to put the shoulder belt under an arm. Page 65 around the child restraint so that it is not necessary to use a locking clip. The cinching latch plate will keep the belt tight, however, any seat belt system will loosen with time, so check the belt occasionally and pull it tight if necessary. For some older child restraints, many child restraint manufacturers offer add-on tether strap kits or retro-fit kits.

You are urged to take advantage of all the available attachments provided with your child restraint in any vehicle. Not all child restraint systems will be installed as described here.


2007 Chrysler Aspen - Owner's Manual (472 pages)



Chrysler 2007 Aspen Owner's Manual


Related Articles